关于风筝活动作文英语_初二真题英语作文3篇

作者:用户投稿 2023-04-22 05:51:53 阅读：326 点赞：0

关于”风筝活动“的英语作文范文3篇，作文题目：Kite activity。以下是关于风筝活动的初二英语范文，每篇作文均为真题范文带翻译。

高分英语作文1：Kite activity

Let the kite tool: starch kite, paper knife material: thin bamboo strip, gauze, spicy paper, this square kite, now used more, the most common kite skeleton, using two extremely simple composition procedures, although simple, but the shape changes very much, plus a period of free time can do a lot of things: first, soak the thin bamboo strip, make the thin bamboo strip soft, and then Use a knife to break the thin bamboo strip, about three roughness, and then repair half of the shape, because in the future, the thin bamboo strip must be pasted on the spicy paper. If it is too thick, the thin bamboo strip can break the paper. At the same time, the thin bamboo strip is too thick, and the gauze paste is unstable. 关于风筝活动作文英语_初二真题英语作文3篇

Plan and complete two suitable lengths of the thin bamboo strip. The next step is to plan and complete the four directions of the horse drawn paper, with a length of about □, Mala paper is a kind of very rough paper. When it is suitable for kite use, thin bamboo strips can be pasted on the paper.

However, it must be recorded that the long and thin bamboo strips are sandwiched in one of the three short strips with a paper towel, and then they are bent slowly until the long and thin strips touch the paper. Generally, they are pasted on the last step of the kite, and the tail of the kite is pasted under the kite You can get up and fly a kite. The tail is the main tool to balance the kite.

When the kite flies on time, the kite can lean to this side, but the tail is better to be longer, because the weight of the kite will be raised at the forehead, which makes the whole body cold. The balanced wind Zheng silk thread can be divided into round line windlass and one windlass windlass A row of windlass grabs the line on the kite and must become a drift angle o (∩∩) O.

中文翻译：

让风筝工具：淀粉风筝，纸做刀材质：薄竹条状、纱纸、麻辣纸这种四方形的风筝，现在用的多，最通用的风筝骨架，单用两个构图极其简单的程序虽然简单，但外形变化非常多，加上一段空闲时间就可以做成很多事情的程序：先把薄竹条浸湿，使薄竹条柔软，再用刀把薄竹条折开，大约三个粗糙度，然后修补半个形状，因为以后一定要把薄竹条贴在麻辣纸上，如果太厚，薄竹条可以拉破纸，同时薄竹条太厚，纱纸糊不稳，将细竹条计划并完成两个长度合适的长度，大约下一步，就计划和完成马拉纸四个方向，长约□□，马拉纸是一种非常粗糙的纸，适宜作风筝使用时可将薄薄的竹条粘贴在纸上，但必须记录，长而细的竹条，用纸巾夹在短三条中的一条，然后慢慢弯曲，直到长而细的竹条始末触纸一般将其贴在风筝的最后一步上，把风筝尾贴在风筝下面，好后线和风筝的角度，就可以起来放风筝尾是平衡风筝的主要工具，当风筝乘风而准时，如果放风筝的时候，风筝可以偏这边，但尾巴最好比较长，因为现在长了会有重量的风筝前额抬高，使全身发冷，有平衡的斜边风筝丝线可以用牛皮胶线、棉线、玻璃线等起锚机来分圆线起锚机和一个一排卷扬机抓住风筝上的线，必须变成一个漂移角O（∩∩）O。

万能作文模板2：风筝活动

The procedure for making a kite is to cut two lengths of dowel bars, one inch long and the other inch long. Measure each cut with a ruler. Mark the shorter inch part at half of its length and mark the longer inch part at one third of its length.

The two poles are at right angles, one on top of the other, so that the marks touch the two poles. Form a cross shaped step with a strong string. Tie the two rods together, tie a safe knot at their meeting, and cut off the redundant rope step.

Use a utility knife to cut a small cut at the end of the two rods. These notches will hold the rope that gives the kite a shaped step. Put some line in the slot at the top of the kite rack.

When the rope is fixed on the top of the kite pole, wrap it around the top of the pole step and tightly around the edge of the frame. Make sure that when you return to the top of the kite rack, it is firmly installed in each slot of the pole step, and the end of the kite is tied to the shelf with a rope When cutting paper with scissors or utility knives, leave about 1 / 2 inch of excess: apply glue along the outer edge of the paper, then fold it up so that it can wrap the rope and fix it to the paper in the frame, while making sure that enough glue is used and evenly spread over the steps that attach the paper to both the rope and itself: short Each end of the pole should be tied with a rope, the length of which should be a little longer than the step of the pole: tie another rope to both ends of the pole, and the rope should be a little longer than the step of the pole: take two ropes with one hand, find their overlap in front of the kite, and tie them together with a little extra rope. This is the place where you should tie the kite line when you fly a kite.

To make a tail for your kite, fix it http://wwwehowcom/howmakekitehtmlhttp ://wwwtutorialscom///asp.

中文翻译：

如何制作一个风筝的步骤切割两个长度的暗销杆，一英寸长，另一英寸长的步骤用尺子测量每个切割的部分，在其长度的一半处标记较短的英寸部分，并在其长度的三分之一处标记较长的英寸部分。两个杆呈直角，一个放在另一个上面，使标记接触到两根杆，用结实的细绳形成一个十字形台阶，将两根杆绑在一起，在它们相遇处系上一个安全的结，并切断多余的绳子台阶使用一把实用刀在两根杆的末端切出一个小切口。这些槽口将固定使风筝有形状台阶的绳子把一些线放在风筝架顶部的槽口中，当绳子固定在风筝杆顶部时，将其绕在杆台阶的顶部，将其紧紧地绕在框架的边缘，确保当你回到风筝架顶部时，它牢固地安装在杆台阶的每个槽口中，把风筝的末端用一根绳子绑在架子上，用剪刀或多功能刀剪纸时，请留出大约1/2英寸的多余部分：沿着纸张的外缘涂抹胶水，然后将其折叠起来，这样它就可以将绳子包裹起来，并将其固定在框架内的纸张上，同时确保使用足够的胶水并将其均匀地摊铺到把纸同时贴在绳子和它本身的台阶上：在短杆的每一端绑一根绳子绳子的长度应该比杆的台阶长一点：再把另一根绳子系在长杆的两端，绳子应该比杆的台阶长一点：用一只手拿起两根绳子，在风筝的前面找到它们重叠的地方，用一点额外的绳子把它们绑在一起。

这是你在放风筝的时候要系上风筝线的地方。为了给你的风筝做一个尾巴，固定好http://wwwehowcom/howmakekitehtmlhttp://wwwtutorialscom///asp。